GPS Logger Shield U-Blox NEO-6M SPI-UART with Micro-SD Card Slot for Arduino

Save 21%
CreateLabz StoreSKU: 60-020

GPS Logger Shield: Module Only
₱779 ₱990

Shipping calculated at checkout

Only 1 unit left


GPS Logger Shield equips your Arduino with access to a GPS module, SD memory card socket, and all of the other peripherals you'll need to turn your Arduino into a position-tracking, speed-monitoring, altitude-observing wonder logger. The shield is based around a uBlox's NEO-6M GPS Module, a 66-channel GPS receiver featuring a MediaTek MT3339 architecture and up to a 10Hz update rate. 

A switch allows you to select the GPS module's UART interface between either hardware or software ports. The regular GPS pins(RX, TX) can be connected to D0-D7 of Arduino.  The SD card operates over a hardware SPI port, which should be compatible with most Arduino layouts.

On-Board U-blox NEO-6M GPS Module
External active GPS antenna design with high receive sensitivity, compatible normal antenna
Onboard rechargeable battery enables backup parameters ability
SD memory card socket
Standard Arduino sized shield
Arduino reset button
UART jumper controls serial communication


  • Material: ABS
  • Size: Approx. 6.8*6.4*1.9cm/2.68*2.52*0.75inch
  • Model: NEO-6 U-blox 6 GPS
  • Pin: For Arduino/MEGA Board
  • Operating temperature: -40-85℃
  • Supply voltage: 3.3-5V
Package List:
1 x GPS Logger Shield

Note: Product Images are shown for illustrative purposes only and may differ from the actual products.

Customers who bought this item also viewed

You recently viewed this item