Dual Bridge DC motor driver module for Arduino DC 5V-24V/15A/30A/ Peak

CreateLabz StoreSKU: 35-021


Shipping calculated at checkout

Sold out



  • The driver focuses on the current and efficiency, effectively the power of the engine, and the life of the battery. 
  • It can withstand high current overload, the maximum current up to 30A. 
  • This unit also has a brake function that can quickly stop the engine, brake quickly, obvious braking, easy to implement this feature. 
  • The unit uses two + low resistance n-channel MOSFET components full half-bridge driver chip. Full half-bridge driver
  • Reliable drive mode chip, MOSFET switching losses to a minimum. Improve energy utilization! The MOSFET driver chip comes with
  • Hardware brake function and power feedback.
  • N channel MOSFET IRF3205 MOSFET, use two dedicated half-bridge driver chips in the top tube using a bootstrap capacitor,
  • So that the tube has enough MOSFET channel drive voltage can be opened quickly, improve the acceleration curvature of the motor,
  • But also quickly for the engine brake. This allows the car to start quickly and can kill the car quickly.
  • The driver can work at 0% -99% of the PWM modulation cycle, the motor drive voltage can be obtained sufficiently.


  • Rated voltage: DC 3V ~ 36V
  • Rated current: 15A
  • Peaks: 30A
  • Size: 108x58mm
  • Forward motor: DIR = 1 PWM = PWM
  • Reverse motor: DIR = 0 PWM = PWM
  • Parking brake: DIR = X PWM = 0 (X is any state)
  • Connection: Power connects with positive power; GND connects with negative power; 2 motors are respectively connected with MOTOR 1, MOTOR 2.
Uses: for DC motor control circuit
Package Included:
1 x Dual Channel DC Motor Control Board

Customers who bought this item also viewed

You recently viewed this item